---
catalog: WEB-I3
catalog_name: Insulating Glass Fabrication Supplies
page: 13
sku_count: 0
generated_at: "2026-05-21T23:30:08Z"
---

# Insulating Glass Fabrication Supplies -- Page 13

## Page Content

FHC INSULATING GLASS FABRICATION, SUPPLIES, AND EQUIPMENT
Keyword
Visit fhc-usa.com to search for
Enter the Item Number or scan QR code with  
your smartphone for complete product details
SECTION 2
FHC IG Fabrication Methods
IG11
Bulk Quantities Available
Click to Chat With Us
Super Spacer
Visit fhc-usa.com to search for
Enter the Item Number or scan QR code with  
your smartphone for complete product details
SECTION 2
FHC Silicone 
Foam Super  
Spacer® Notcher
1. Once the liner is stripped from the Super Spacer, with the foil
surface facing the operator, insert spacer into the notcher
shuttle tool between the pressure wheel and the guide roller
2. To load, pull the spacer through so that it extends beyond the
pressure wheel and parallel to the base of the tool. Once the
cutting blade is engaged and you’re ready to notch a corner,
activate the punch trigger
3. Position the spacer so that the bottom spacer edge exceeds the
tool base by about 1/32"
4. Place the guide block against the side of the first glass lite and
align with the starting corner of the glass. Once aligned, tack
down by applying pressure
5. Support the spacer tape slightly above the glass surface. While
maintaining the tape perpendicular to the glass, apply slight
downward pressure and glide the tool along the glass edge
toward the second corner
6. Glide the tool along the glass edge until the next corner is
reached. Press the notcher punch trigger to activate the
notcher punch
7. Continue moving the tool straight ahead until the left side of the
notch is aligned with back edge of the faceplate. Press down on
the spacer to ensure good adhesion
8. Tack down spacer at about 1" distance from the corner. Proceed
with spacer application, repeating steps at the second and
third corner
9. At a point approximately 1" from the final corner, guide the tool
slightly outward to avoid hitting the starting end of the spacer.
Notch and cut off the spacer end and remove tool by pulling it
forward and off the previously applied spacer
10 Manually align the spacer ends to form the final corner joint
For videos and the complete instructions visit fhc-usa.com.
ATTENTION: The FHC Super 
Spacer® contains a desiccant 
and must not be left out in 
the open air for any duration. 
Ensure that any material not 
immediately used is repacked in 
the provided foil bag and then 
securely stored in a Ziplock bag 
or a similar container that is 
hermetically sealed.
Typical Corner Notch
Finished Corner 
CORNER 
CUT-OUT
GLASS
SPACER
GLASS
SPACER
CORNER 
CUT-OUT
GLASS
SPACER
A.
B.
C.
	- Hand-Held Pneumatic Tool for a Continuous Process
	- Space Width Adjustment Can Accommodate 
Sizes from 3/16" to 15/16"
	- Fixed Setback Distance for
Straight-Line Application
	- Circular Punch for Corner Notching
	- Cutting Blade or Final Spacer Cut-Off
 ITEM NO. QSSPN1
 Pneumatic Notcher
Super Spacer is a registered trademark of Quanex Building Products Corp.
FRAMELESS HARDWARE COMPANY LLC
2323 Firestone Blvd. South Ga

*(truncated, 3,102 chars total)*